Hi,
I’m struggeling a bit with doing prints with my thermal printer in Order Printer with macbook. I have a PC too, an there it works fine.
I use 4x3" lables, as I don’t need bigger on my envelopes. I have understood that is a little bit different from most.
First problem is that I can’t get it to print in landscape as default. If I go into the advanced settings I can make it print in landscape, but the setting is not possible to save, and there are a lot of margins, around 13mm. And this is not the case with PC.
I read another post here in the forum that print size can be adjusted in order printer, but I can’t find it. Mabe that option has been deleted.
Has anyone succeeded with this, it would be greatly appreciated if it can be done.
I don’t want to buy a PC just for this issue!
Please see pictures.
P.s.
If I print a 4x3" shipping label via pdf without margins it fills good, but same issue with default portrait orientation.
Thanks Gordon